CANTON ALUMINUM COOLANT EXPANSION - POWER STEERING TANK
05-08 MUSTANG GT/SHELBY GT500

We are proud to announce the introduction of the newest addition to our Mustang parts accessories selection. RPM Outlet now offers Canton Racing Products Aluminum Coolant Expansion tank, and Power steering Tank.

• Direct bolt-in replacement for plastic tank
  
  
• Fabricated Aluminum for strength
  
  
• Uses factory stock vented cap
  
  
• Integral billet aluminum fittings
  
  
  
  Part# MOR63768 $ 139.99
  
  Click-On Price to Order

This lightweight aluminum is a direct bolt-in replacement for '05-08 V-8 Mustang's. Offers increased strength over the factory plastic tank. Baffled for proper fluid control and comes with the neccassary bracket, fittings and top for a direct bolt-in fit. Tank can be polished for a high shine or anodized for a personal touch.


• Mustang GT '05-'08
• Shelby GT500 '07-'08
  
  Part# MOR63491 $ 99.99
  
  Click-On Price to Order

If you have a 2005+ Mustang and it has doors, then you need a set of these Aluminum Mustang GT500 SVT Still Plates!

Cover up that dingy Ford plastic still plates with Authentic 07-08 GT500 aluminum still plates giving your car mad open door appeal!

Best yet they work on every 05-08 Mustang; v6 or v8 models.

• Fits 2005-08 Mustangs
• Improves appearance and protects vehicle entry area
• Black with brushed stainless steel insert with “SVT” logo
• Simple Adhere/Clip-on Plates
• Easy Install no drilling or screws Kit includes two sill plates, installation tape and instructions
  
  
  Sold is set of (2) two
  
  Part # FMS-M-13208 $ 99.99
  
  

      Click-On Price to Order

This is the latest of the must have part for your 05-08 Mustang. The Ford Racings dash mounted remote starter button is designed to replace the existing power point located in the center of the dash.

Easy to install designed to enhance the appearance of your 2005-08 Mustang, simply turn the key to the on position then press the button, includes special wire harness for easy installation.

Best yet they work on every 05-08 Mustang; v6 or v8 models.

• Fits All 05-08 Mustangs
• Fits in the existing Power Point located in the center of the dash
• Turn the key to the on position then press the button
• Kit includes special wire harness for easy installation, and installation instructions
• Red illumination only
  
  
  Part # FMS-M-11572-GT $ 105.99
  
  

      Click-On Price to Order

What's an underdrive pulley?

An underdrive pulley is a replacement pulley that bolts up the same as stock, but has a different size (ratio) and material specifications intended to free up lost horsepower. By increasing the diameter of each accessory pulley and decreasing the size of the crank pulley, the speed at which the accessories are turning relative to engine RPM decreases.

Under drive pulleys do not add power to the engine, they free up the power that is normally wasted on overdriven accessories. The theory is that a larger pulley will drive the accessories slower thus reducing their parasitic horsepower loss. No more power total, but more power sent to the wheels. As an additional benefit, the reduction in wear (less usage) on the accessories due to the lower duty cycles can extend the life of these parts.

For example, the alternator, power steering, water pump and air compressor rob horsepower from the engine. By replacing factory-sized crank balancer/pulley and water pump drive pulley with a resized pulleys, the accessories are slowed, resulting in more horsepower available to the drive wheels.

MOTOBLUE™ H.O. Series pulleys will increase horsepower up to 16 RWHP, and increase mileage by 1 to 2 MPG. MOTOBLUE H.O Pulleys are manufactured from billet steel, exceeding factory quality and are the only Pulley system available on the market today that are SFI approved for all racing applications.

Installation: The kit includes all required components and hardware for a complete installation.
Tech Notes: Use of Harmonic Balancer Puller tool required for factory Harmonic Balancer removal.

MOTOLUE™ 25% Under-drive Crank (harmonic balancer) Pulley
• Manufactured from Billet Steel and Aluminum
• Adds 16.2 HP and 12.3 ft/Lb Torque

Note: This kit is compatible with factory anti-lock brakes and traction control systems.

Click-On Price to Order