JLT Performance Series II Cold Air Intake For 2011-2014 Ford Mustang GT 5.0 / Boss

Fits Vehicle: 2011-2014 Ford Mustang GT 5.0 / Boss

GAINS AND TESTING:
30-35 average RWHP gain over stock

– Cotton Cleanable

• FILTER TYPE – COTTON
• OIL COLOR – RED
• REPLACEMENT FILTER – SBAF57-R
• STREET LEGAL IN ALL US STATES – NO
• TUNE REQUIRED – YES

ALL NEW JLT SERIES II for 2011-2014 Mustang GT 5.0 and 2012-2013 Boss 302
Have an aftermarket manifold like a Boss or Sniper?  Then this is your cold air intake!

This new kit was designed from the ground up to work with today’s aftermarket manifolds and throttle bodies. Released back in 2010, JLT’s original kit has worked great on the 5.0 for over 7 years. With the release of the BOSS and now the Holly Sniper along with 85 and 90mm throttle bodies, we decided to do a redesign to accommodate these different sizes and angles. Designed to fit and work with the stock manifold as well as the BOSS and Holley Sniper.

It starts with a 4″ opening at the throttle body to match up to those 90mm units. The kit comes COMPLETE with 2 couplers. One 4″ straight for the 90mm and a 4-3.5″ reducer for the stock unit.

Next is the perfect 112mm MAF housing. Up from 107mm on the original, but not so big to cause drivability issues. Oh and the MAX allowed in NMRA Coyote Stock racing. At the MAF you attach our one-off designed S&B filter. A massive 5″ at the inlet with a full radiused bellmouth to huge 1″ deep pleats, this thing flows tons of air.

Finally, all this sits in our own designed Roto Molded heat shield that utilities the factory fresh air inlet to get you the coolest air possible. Finish it off with a silicone coupler and stainless clamps and you got the BEST Intake on the market!! No metal tubing here.

MOLDED-IN MAF
It’s a full 112mm ID at the MAF area
MAF is rotated to the inside or engine side of the tube for a more pleasing smooth look

HEATSHIELD
Includes roto-molded plastic heat shield to block engine heat at idle and low speed.
It incorporates the fresh air inlet from the grill.
It uses a large area to make sure the filter has tons of cool air.

KIT INCLUDES:

• JLT Intake Tube with Black Textured finish
• 4″ Silicone Coupler for aftermarket throttle bodies
• 4-3.5″ Silicone reducer for stock throttle bodies
• 5×7″ S&B Power stack Air Filter
• Roto molded Heat Shield
• HD Clamps, 2013-14 hood insert plug & all needed hardware

GAINS AND TESTING
30-35 RWHP from stock with custom tune (gains from both tune and intake)
2-4 RWHP over our original JLT CAI on a stock GT
8-10 RWHP over our original JLT CAI on a BOSS
10-14 RWHP over our original JLT CAI on a modded GT
We have tested this on three different cars with different stages of mods and all gained over the original kit.

TUNING
A JLT specific tune is required with this kit.

2013-14 owners: KIT INCLUDES OUR WATER BLOCKER PLUG INSERT FOR NO WORRIES ABOUT WATER GETTING TO THE FILTER.

*This product is NOT CARB (California Air Resource Board) Exempt. It is not for legal sale or use in the state of CA or any other states adopting CA emission standards and require a CA Executive Order (EO) number. Any orders placed for this item with a CA ship to address will be canceled.

Brand

JLT Performance